Steam Filter Replacement and FAQ

How to install the water filter assembly? 

Some models with Steam Assist will also come with a water filter assembly that can be mounted under the sink or nearby cabinet. 

For best results, do not install the water filtration system outside or in extreme hot or cold temperatures. The temperature of the water supply to the water filtration system must be between 40°F (4°C) and 100°F (38°C). Locate the water filtration system near the cold water supply pipe under the kitchen sink to filter cold water. Make sure that the water filter assembly is installed in an upright position. It will be necessary to drill a 1/2" (1.3 cm) minimum diameter hole in the upper-right or left rear corner of the side wall of the cabinet under the sink to route the water supply tubing through to the range. Depending on your installation configuration, more routing holes may be required. Coil enough flexible codes-approved water supply tubing behind the range to allow for the connection to the range to be made behind the range before setting the range in place.

Where is the water filter located? 

The water filter will be attached to the water filter housing, most likely under the sink or where ever it was installed. 

How to replace the water filter? 

Unscrew the filter from the housing and then replace it with a new filter.  You can find the replacement water filter number in the Owner's Manual.