Skip to main content

How to Perform an AquaLift Clean Cycle

How to Perform an AquaLift® Clean Cycle in a Jenn-Air Appliance

To Clean:

Note: Allow the oven to cool to room temperature before using the Clean cycle. If your oven cavity is above 200°F (93°C), “Oven Cooling” will appear in the display, and the Clean cycle will not be activated until the oven cavity cools down.

  1. Remove all racks and accessories from the oven cavity and wipe excess soil. Use a plastic scraper to remove easily removed soils.
  2. Pour 1¾ cups [14 oz (414 mL)] of distilled or filtered water onto the bottom of the empty oven and close the oven door.
    • IMPORTANT: Do not use chemicals or other additives in the water. Do not open the oven door during the Clean cycle. The water on the oven's bottom is hot.
  3. Press AquaLift® SELF CLEAN and then START on the oven control panel.
  4. Allow 40 minutes for cleaning and cool down. A beep will sound when the Clean cycle is complete.
  5. Press CANCEL at the end of the cycle. Cancel may be pressed at any time to stop the Clean cycle.
  6. Remove the residual water and the loosened soil with a sponge or cloth immediately after the Clean cycle is complete. Much of the initial 1¾ cups [14 oz (414 mL)] of water will remain in the oven after the cycle is completed. If additional soils remain, leave a small amount of water in the oven bottom to assist with the cleaning.
  7. If any soils remain, remove them with a non-scratch scrubbing sponge or plastic scraper. Additional Clean cycles may be run to help remove the stubborn soils.
IMPORTANT: Do not use oven cleaners. Chemicals, including commercial oven cleaners or metal scouring pads, may permanently damage the porcelain surface of the oven interior.

Tips for Better Results:

  • Make sure the range is level. This will ensure the bottom of the oven cavity is covered by water.
  • Use distilled or filtered water. Tap water may leave mineral deposits on the oven bottom.
  • Before removing the residual water and loosened soils at the end of the Clean cycle, insert a cloth or paper towel between the lower edge of the oven door and the front frame to keep water from spilling onto the front of the range and the floor.
  • Non-abrasive scrub sponges or eraser-style cleaning pads (without cleaners) can be useful for cleaning the oven cavity walls, oven door, and oven bottom for difficult soils. For best results, moisten the pads and sponges before use.
  • Run an additional Clean cycle for stubborn soils.
  • affresh® Cooktop Cleaner may be used to clean the oven bottom, walls, and door when the oven has finished the cycle and returned to room temperature. If the affresh® Cooktop Cleaner is used, it is recommended that the cavity be wiped out with distilled water as well. 
  • Additional AquaLift™ Technology Cleaning Kits are available.
Cleans even where you can't see

affresh® cleans deep inside your appliances reaching components such as the tub, racks, pump, valves, drain, and recirculation hoses.

Cleaners are available at many retailers or can be purchased here.

affresh logo1.jpg