Leaking - Underneath - Dishwasher

Is the water supply connected correctly?

Check all the connection points.  Be sure the rubber washer is properly seated in the fitting for any connection point. Slide the 3/4" (19 mm) fitting of the 90° elbow up to the valve and hand tighten it to avoid cross-threading. Hand tighten until the coupling is tight. Using pliers, check the tightness of the coupling. Sealing the rubber gasket may require an additional 1/4 to 1/2 turn. Make sure to route the fill hose out to the rear left side of the unit.

CLICK HERE for additional information on the water supply

Is the Drain Line installed correctly?

Verify that the drain hose has been properly connected.

CLICK HERE for more information about the proper installation of the drain line